Dräger REGARD 1000
Flexible evaluation system for up to four transmitters
- Flexible evaluation system for up to four transmitters
- Equipped with three freely configurable alarm relays and one fault relay
- Data logging for efficient recording and analysis of the gas detection system
- Can be mounted in a control cabinet or on the wall
Highlights
The Dräger REGARD 1000 is a versatile gas detection controller for up to four transmitters, with three freely configurable alarm relays. Operate it easily via a six-button interface. Install it in a control cabinet or mount it on a wall so it fits into your work environment. The data logging function makes it easy to collect and analyse a wide range of information from the gas detection system.
Ready-to-use
The Dräger REGARD 1000 comes in two practical versions: as a robust wall-mounted unit with built-in power supply, ready to install directly on a wall, and as a control-cabinet module for cost-effective DIN-rail mounting in existing cabinets. Just connect it and the system is ready to go.
Easy operation and interfaces
Configure the Dräger REGARD 1000 with ease via six control buttons and a graphic LC display on site. Messages and alarms are easy to view and acknowledge. Alternatively, configure it from a PC using the built-in USB-C port for data transfer.
Robust and safe
The wall-mounted unit is dust-tight and splash-proof (IP65), offering full protection and high safety in daily use.
Data logging
Log events, statuses and readings in real time, either on trigger or at set intervals, to an SD card.
Scope of delivery: Dräger REGARD 1000 Wall Unit
- 1 REGARD 1000 (Cabinet Module)
- 1 24 V DC power supply (approx. 100 W)
- 1 Wiring between terminal blocks, power supply and REGARD 1000 (supply voltages)
- 1 Base housing with pre-cut threads 6x M16 and 8x M20 for cable glands
- 1 Top housing, frame with transparent section, hinged and opening upwards
- 1 Terminal compartment cover with fixing screws, including central cut-out (width: 9 division units)
- 1 Mounting plate with DIN rail, pre-mounted with screws in base housing
- 1 M20 plastic cable gland with pressure equalisation membrane
- 2 M20 plastic cable gland
- 5 M20 plastic blanking plug
- 6 M16 plastic blanking plug
- 3 DIN-rail terminal block (L, N, PE), colour-coded and labelled
- 1 Installation guide with drilling template
